The 14 sizes of normal roller chains are available ranging from 25 to 240 which include individuals in conformity with ANSI (American National Common Institute), and ISO (International Organization for Standardization).
The chains not only meet the demands to the minimal tensile power prescribed by ANSI and ISO, nevertheless they also supply the major class high quality from the world like a higher fatigue power
Appropriate employs
?Basic use for driving and lifting ELEVATOR BUCKETS products.
Examples
?Driving transfer units and various products. For multilevel parking.
Selection of chains
For choice of a chain, see the tables of “Max. Horsepower Ratings” for common roller chains and “Designing of Chain Transmission”. On the other hand, only for any distinctive case of reduced velocity and significantly less shock, “Low-speed selection” strategy also can be referred to.
Standard roller chains up to five strands can be found. The common strategy for connecting pins and plates is rivet variety (RP).
The cotter variety (CP) is available for normal chains and HK chains of 80 or greater.
Sprockets
The conventional roller chains could be engaged with normal sprockets with the corresponding nominal numbers. For sprockets, refer for the table of “Dimensions” for every size of chain.
Connecting back links and offset hyperlinks
For connecting links and offset links, refer on the table of “Dimensions” for each dimension of chain.
The connecting backlinks are typically R or C connecting backlinks through which the pins are clearance-fitted with all the connecting plate. Considering that clearance-fitted hyperlinks are inferior towards the base chain in Max. allowable stress as in the case of one-pitch offset back links (OJ), “Low-speed selection” cannot be referred to. Because the Max. kilowatt ratings are determined taking into consideration the power of connecting backlinks and OJ, the clearance-fitted connecting backlinks and OJ could be applied if your chains are selected in accordance to the “General selection”. When a higher Max. allowable tension is needed to the connecting link, use the interference-fitted connecting link (H connecting website link) 
of a HI-PWR-S chain, and during the case of offset back links, use 2POJ.
